PETG settings for the Anycubic Kobra 3

Last updated 9 November 2026

OrcaSlicer's Anycubic Generic PETG profile prints at 255 °C, with the bed at 80 °C and the part fan at 40 to 90 %.

Profile Nozzle Bed Part fan Max flow Retraction
Anycubic Generic PETG 255 °C 80 °C 40 to 90 % 10 mm³/s 1 mm
Anycubic PETG 230 °C 70 °C 15 to 80 % 8 mm³/s 2 mm
AliZ PETG 250 °C 79 °C 30 to 80 % 15 mm³/s 1 mm
AliZ PETG-Metal 260 °C 79 °C 30 to 80 % 13 mm³/s 1 mm
Bambu PETG Basic 255 °C 70 °C 10 to 40 % 13 mm³/s 1 mm
Bambu PETG HF 245 °C 70 °C 20 to 40 % 12 mm³/s 1 mm
Bambu PETG Translucent 245 °C 70 °C 10 to 30 % 6 mm³/s 0.3 mm
COEX PETG 245 °C 80 °C 30 to 50 % 16 mm³/s 4 mm
OrcaSlicer has 36 more PETG profiles for this printer.

How do I set up my file for the Anycubic Kobra 3?

Drop it here. It opens in Convert with the Anycubic Kobra 3 and Anycubic Generic PETG picked, and nothing converts until you click Convert.

Which build plate should I use?

Anycubic Generic PETG sets a bed temperature for each plate:

  • Smooth PEI plate: 80 °C
  • Cool plate: 60 °C
  • Engineering plate: not supported

Why is my PETG stringing?

Wet PETG strings more, so dry it at 60 to 65 °C for 8 hours (Bambu Lab wiki). If the spool is dry, try 5 to 10 °C below the 255 °C that Anycubic Generic PETG sets, but not below its 220 °C floor (Prusa Knowledge Base). Keep the part fan on, since cooling PETG prevents stringing, and lengthen retraction (Prusa Knowledge Base).

Why does PETG print so slowly?

Anycubic Generic PETG caps flow at 10 mm³/s, and the slicer slows any move that would push more plastic than that (slicer source).

Why does my PETG lift or warp?

Anycubic Generic PETG heats the bed to 80 °C, so clean the sheet first, then add a brim (Prusa Knowledge Base). On smooth PEI, apply a glue stick first, since PETG can bond hard enough to damage the sheet (Prusa Knowledge Base).

Where do these values come from?

From the profiles OrcaSlicer ships, read at OrcaSlicer v2.4.2 (8500fcd). Where a filament profile leaves retraction unset, the table shows the printer profile's value.

Something wrong or missing on this page? feedback@lovlar.dev

Slicer and printer names belong to their owners. preslice is not affiliated with them.