PETG settings for the Anycubic Kobra S1
Last updated 9 November 2026
OrcaSlicer's Anycubic PETG profile prints at 250 °C, with the bed at 70 °C and the part fan at 30 to 90 %.
| Profile | Nozzle | Bed | Part fan | Max flow | Retraction |
|---|---|---|---|---|---|
| Anycubic PETG | 250 °C | 70 °C | 30 to 90 % | 12 mm³/s | 1.5 mm |
| AliZ PETG | 250 °C | 79 °C | 30 to 80 % | 15 mm³/s | 0.8 mm |
| AliZ PETG-Metal | 260 °C | 79 °C | 30 to 80 % | 13 mm³/s | 0.8 mm |
| Bambu PETG Basic | 255 °C | 70 °C | 10 to 40 % | 13 mm³/s | 0.8 mm |
| Bambu PETG HF | 245 °C | 70 °C | 20 to 40 % | 12 mm³/s | 0.8 mm |
| Bambu PETG Translucent | 245 °C | 70 °C | 10 to 30 % | 6 mm³/s | 0.3 mm |
| COEX PETG | 245 °C | 80 °C | 30 to 50 % | 16 mm³/s | 4 mm |
| Elas PETG Basic | 250 °C | 80 °C | 20 to 100 % | 13 mm³/s | 0.8 mm |
| OrcaSlicer has 35 more PETG profiles for this printer. |
How do I set up my file for the Anycubic Kobra S1?
Drop it here. It opens in Convert with the Anycubic Kobra S1 and Anycubic PETG picked, and nothing converts until you click Convert.
Which build plate should I use?
Anycubic PETG sets a bed temperature for each plate:
- Textured PEI plate: 70 °C
- Smooth PEI plate: 70 °C
- Cool plate: 55 °C
- Engineering plate: not supported
Why is my PETG stringing?
Wet PETG strings more, so dry it at 60 to 65 °C for 8 hours (Bambu Lab wiki). If the spool is dry, try 5 to 10 °C below the 250 °C that Anycubic PETG sets, but not below its 220 °C floor (Prusa Knowledge Base). Keep the part fan on, since cooling PETG prevents stringing, and lengthen retraction (Prusa Knowledge Base).
Why does PETG print so slowly?
Anycubic PETG caps flow at 12 mm³/s, and the slicer slows any move that would push more plastic than that (slicer source).
Why does my PETG lift or warp?
Anycubic PETG heats the bed to 70 °C, so clean the sheet first, then add a brim (Prusa Knowledge Base). On smooth PEI, apply a glue stick first, since PETG can bond hard enough to damage the sheet (Prusa Knowledge Base).
Where do these values come from?
From the profiles OrcaSlicer ships, read at OrcaSlicer v2.4.2 (8500fcd). Where a filament profile leaves retraction unset, the table shows the printer profile's value.