TPU settings for the Anycubic Kobra S1
Last updated 9 November 2026
OrcaSlicer's Anycubic TPU profile prints at 205 °C, with the bed at 55 °C and the part fan at 100 %.
| Profile | Nozzle | Bed | Part fan | Max flow | Retraction |
|---|---|---|---|---|---|
| Anycubic TPU | 205 °C | 55 °C | 100 % | 3.2 mm³/s | 0.8 mm |
| Bambu TPU 95A | 230 °C | 35 °C | 100 % | 3.6 mm³/s | 0.4 mm |
| Bambu TPU 95A HF | 230 °C | 35 °C | 100 % | 12 mm³/s | 0.8 mm |
| COEX TPE 30D | 240 °C | 35 °C | 80 to 100 % | 3.5 mm³/s | 0.4 mm |
| COEX TPE 40D | 240 °C | 35 °C | 80 to 100 % | 5.5 mm³/s | 0.4 mm |
| COEX TPE 60D | 240 °C | 35 °C | 80 to 100 % | 6.5 mm³/s | 0.4 mm |
| COEX TPU 60A | 225 °C | 35 °C | 80 to 100 % | 1 mm³/s | 0 mm |
| Elegoo Rapid TPU 95A | 230 °C | 35 °C | 100 % | 12 mm³/s | 0.4 mm |
| OrcaSlicer has 8 more TPU profiles for this printer. |
How do I set up my file for the Anycubic Kobra S1?
Drop it here. It opens in Convert with the Anycubic Kobra S1 and Anycubic TPU picked, and nothing converts until you click Convert.
Which build plate should I use?
Anycubic TPU sets a bed temperature for each plate:
- Textured PEI plate: 55 °C
- Smooth PEI plate: 55 °C
- Cool plate: 35 °C
- Engineering plate: not supported
Why won't my TPU feed?
Feed TPU from a spool that turns freely, since drag on the soft filament starves the nozzle (Bambu Lab wiki). Run it through a multi-spool feeder only if the spool is sold for one (Bambu Lab wiki). Print slowly, about 20 mm/s, since a fast feed can tangle TPU in the extruder gears (Prusa Knowledge Base).
Why is my TPU stringing?
Wet TPU strings, so dry the spool first (Bambu Lab wiki). Print the parts one at a time rather than layer by layer, so the nozzle travels less between them (Bambu Lab wiki). If it still strings, lengthen retraction 0.2 mm at a time from the 0.8 mm that Anycubic TPU sets (Bambu Lab wiki).
Do I need to dry TPU?
Yes, dry TPU at 70 °C for 8 hours before printing (Bambu Lab wiki). TPU takes on moisture fast, so store it sealed with desiccant between prints (Bambu Lab wiki).
Where do these values come from?
From the profiles OrcaSlicer ships, read at OrcaSlicer v2.4.2 (8500fcd). Where a filament profile leaves retraction unset, the table shows the printer profile's value.