PETG settings for the Bambu Lab A1
Last updated 9 November 2026
Bambu Studio's Generic PETG profile prints at 255 °C, with the bed at 80 °C and the part fan at 40 to 90 %.
| Profile | Nozzle | Bed | Part fan | Max flow | Retraction |
|---|---|---|---|---|---|
| Generic PETG | 255 °C | 80 °C | 40 to 90 % | 8 mm³/s | 0.8 mm |
| Bambu PETG Basic | 245 °C | 70 °C | 30 to 50 % | 13 mm³/s | 0.4 mm |
| Bambu PETG HF | 240 °C | 70 °C | 30 to 50 % | 18 mm³/s | 0.8 mm |
| Bambu PETG Matte | 235 °C | 70 °C | 30 to 50 % | 13 mm³/s | 0.8 mm |
| Bambu PETG Translucent | 245 °C | 70 °C | 10 to 30 % | 6 mm³/s | 0.3 mm |
| Generic PETG HF | 220 °C | 70 °C | 20 to 40 % | 16 mm³/s | 0.4 mm |
| PolyLite PETG | 255 °C | 80 °C | 40 to 90 % | 8 mm³/s | 0.8 mm |
| SUNLU PETG | 245 °C | 60 °C | 10 to 30 % | 9 mm³/s | 0.8 mm |
How do I set up my file for the Bambu Lab A1?
Drop it here. It opens in Convert with the Bambu Lab A1 and Generic PETG picked, and nothing converts until you click Convert.
Which build plate should I use?
Generic PETG sets a bed temperature for each plate:
- Textured PEI plate: 80 °C
- Smooth PEI plate: 80 °C
- Cool plate: not supported
- Engineering plate: 70 °C
- SuperTack plate: 70 °C
Why is my PETG stringing?
Wet PETG strings more, so dry it at 60 to 65 °C for 8 hours (Bambu Lab wiki). If the spool is dry, try 5 to 10 °C below the 255 °C that Generic PETG sets, but not below its 220 °C floor (Prusa Knowledge Base). Keep the part fan on, since cooling PETG prevents stringing, and lengthen retraction (Prusa Knowledge Base).
Why does PETG print so slowly?
Generic PETG caps flow at 8 mm³/s, and the slicer slows any move that would push more plastic than that (slicer source).
Why does my PETG lift or warp?
Generic PETG heats the bed to 80 °C, so clean the sheet first, then add a brim (Prusa Knowledge Base). On smooth PEI, apply a glue stick first, since PETG can bond hard enough to damage the sheet (Prusa Knowledge Base).
Where do these values come from?
From the profiles Bambu Studio ships, read at BambuStudio v02.09.01.70 (56a57d0). Where a filament profile leaves retraction unset, the table shows the printer profile's value.