PETG settings for the Bambu Lab H2D

Last updated 9 November 2026

Bambu Studio's Generic PETG profile prints at 255 °C, with the bed at 70 °C and the part fan at 40 to 90 %.

Profile Nozzle Bed Part fan Max flow Retraction
Generic PETG 255 °C 70 °C 40 to 90 % 12 mm³/s 0.8 mm
Bambu PETG Basic 250 °C 70 °C 20 to 30 % 18 mm³/s 0.4 mm
Bambu PETG HF 245 °C 70 °C 20 to 30 % 25 mm³/s 0.4 mm
Bambu PETG Matte 245 °C 70 °C 20 to 30 % 18 mm³/s 0.8 mm
Bambu PETG Translucent 245 °C 70 °C 10 to 30 % 6 mm³/s 0.8 mm
Fiberon PETG-ESD 290 °C 60 °C 0 to 100 % 20 mm³/s 0.8 mm
Generic PETG HF 220 °C 70 °C 20 to 40 % 16 mm³/s 0.4 mm
PolyLite PETG 255 °C 70 °C 40 to 90 % 11.5 mm³/s 0.8 mm

How do I set up my file for the Bambu Lab H2D?

Drop it here. It opens in Convert with the Bambu Lab H2D and Generic PETG picked, and nothing converts until you click Convert.

Which build plate should I use?

Generic PETG sets a bed temperature for each plate:

  • Textured PEI plate: 70 °C
  • Smooth PEI plate: 70 °C
  • Cool plate: not supported
  • Engineering plate: 70 °C
  • SuperTack plate: 70 °C

Why is my PETG stringing?

Wet PETG strings more, so dry it at 60 to 65 °C for 8 hours (Bambu Lab wiki). If the spool is dry, try 5 to 10 °C below the 255 °C that Generic PETG sets, but not below its 220 °C floor (Prusa Knowledge Base). Keep the part fan on, since cooling PETG prevents stringing, and lengthen retraction (Prusa Knowledge Base).

Why does PETG print so slowly?

Generic PETG caps flow at 12 mm³/s, and the slicer slows any move that would push more plastic than that (slicer source).

Why does my PETG lift or warp?

Generic PETG heats the bed to 70 °C, so clean the sheet first, then add a brim (Prusa Knowledge Base). On smooth PEI, apply a glue stick first, since PETG can bond hard enough to damage the sheet (Prusa Knowledge Base).

Where do these values come from?

From the profiles Bambu Studio ships, read at BambuStudio v02.09.01.70 (56a57d0). Where a filament profile leaves retraction unset, the table shows the printer profile's value.

Something wrong or missing on this page? feedback@lovlar.dev

Slicer and printer names belong to their owners. preslice is not affiliated with them.