PETG settings for the Flashforge AD5X

Last updated 9 November 2026

OrcaSlicer's Flashforge Generic PETG profile prints at 255 °C, with the bed at 70 °C and the part fan at 80 to 100 %.

Profile Nozzle Bed Part fan Max flow Retraction
Flashforge Generic PETG 255 °C 70 °C 80 to 100 % 12 mm³/s 2 mm
Flashforge HS PETG 235 °C 75 °C 80 to 100 % 12 mm³/s 2 mm
Flashforge PETG Basic 265 °C 70 °C 80 to 100 % 12 mm³/s 2 mm
Flashforge PETG Pro 265 °C 75 °C 10 to 50 % 10 mm³/s 2 mm
Flashforge PETG Transparent 265 °C 75 °C 10 to 50 % 10 mm³/s 2 mm
SUNLU PETG 245 °C 60 °C 10 to 30 % 24 mm³/s 2 mm
AliZ PETG 250 °C 79 °C 30 to 80 % 15 mm³/s 2 mm
AliZ PETG-Metal 260 °C 79 °C 30 to 80 % 13 mm³/s 2 mm
OrcaSlicer has 40 more PETG profiles for this printer.

How do I set up my file for the Flashforge AD5X?

Drop it here. It opens in Convert with the Flashforge AD5X and Flashforge Generic PETG picked, and nothing converts until you click Convert.

Which build plate should I use?

Flashforge Generic PETG sets a bed temperature for each plate:

  • Textured PEI plate: 85 °C
  • Smooth PEI plate: 70 °C
  • Cool plate: 85 °C
  • Engineering plate: 85 °C

Why is my PETG stringing?

Wet PETG strings more, so dry it at 60 to 65 °C for 8 hours (Bambu Lab wiki). If the spool is dry, try 5 to 10 °C below the 255 °C that Flashforge Generic PETG sets, but not below its 220 °C floor (Prusa Knowledge Base). Keep the part fan on, since cooling PETG prevents stringing, and lengthen retraction (Prusa Knowledge Base).

Why does PETG print so slowly?

Flashforge Generic PETG caps flow at 12 mm³/s, and the slicer slows any move that would push more plastic than that (slicer source).

Why does my PETG lift or warp?

Flashforge Generic PETG heats the bed to 70 °C, so clean the sheet first, then add a brim (Prusa Knowledge Base). On smooth PEI, apply a glue stick first, since PETG can bond hard enough to damage the sheet (Prusa Knowledge Base).

Where do these values come from?

From the profiles OrcaSlicer ships, read at OrcaSlicer v2.4.2 (8500fcd). Where a filament profile leaves retraction unset, the table shows the printer profile's value.

Something wrong or missing on this page? feedback@lovlar.dev

Slicer and printer names belong to their owners. preslice is not affiliated with them.